Gas Dryer Vent and Carbon Monoxide: What Seattle Homes Should Check This Winter

November is when Seattle houses close up. Windows stay shut, the furnace kicks on, and the laundry piles up with wet rain gear, towels, and bedding. If your dryer runs on natural gas, that is also the time of year when a clogged or disconnected vent stops being just a lint problem and becomes an air problem inside your home.
A gas dryer burns fuel to make heat. Burning fuel makes exhaust, and that exhaust includes carbon monoxide (CO) along with a lot of water vapor. The only thing carrying it out of your house is the dryer vent. When that vent is packed with lint, crushed behind the machine, or pulled loose in the crawlspace, the exhaust has nowhere good to go.
Here is what Seattle homeowners with gas dryers should know, what to check this month, and when to call us.
How a Gas Dryer Vent Keeps Carbon Monoxide Out of Your Home
An electric dryer pushes out hot, wet, linty air. A gas dryer pushes out the same thing plus combustion gases from the burner. Both depend on one job getting done: air has to move freely from the back of the dryer, through the duct, and out the exterior hood or roof cap.
When that path is open, the exhaust leaves the house in seconds. When it is restricted, a few things happen at once:
The blower can't push the full volume of air out, so hot, moist exhaust backs up in the duct.
Exhaust looks for the easiest way out. That can mean a loose joint behind the dryer, a split in a foil or vinyl duct, or a disconnected section in the wall or crawlspace.
The dryer runs longer to finish each load, which means the burner fires longer and makes more exhaust.
Carbon monoxide has no color and no smell. You will not notice it the way you notice a burning-lint smell. That is why the vent itself, and a working CO alarm, matter so much in a gas-dryer home.
Why Seattle Winters Raise the Stakes for Gas Dryer Vents
Seattle doesn't get brutal cold, but our winters are long, wet, and closed-in. That combination works against a weak dryer vent.
Tighter, closed-up houses. From November through March most of us keep doors and windows shut. Whatever spills from a leaky duct stays inside longer.
Heavier, wetter loads. Rain jackets, soaked towels, and muddy kid gear mean more lint and more moisture going through the duct. Wet lint sticks to duct walls and exterior screens instead of blowing out. We covered that in detail in our post on dryer vent condensation in Seattle.
Long, tangled runs. Townhomes, condos, and older houses in neighborhoods like Capitol Hill, Ballard, and West Seattle often route dryer exhaust through long runs, multiple elbows, or up to the roof. Every turn is a place for lint to collect. If your vent runs a long way, our post on booster fans and long vent runs in Seattle townhomes explains why those runs clog faster.
Winter windstorms. Storms knock exterior hoods loose and jam flappers. A flapper stuck shut on a gas dryer is a blocked exhaust path.
Washington lawmakers took CO seriously after the December 2006 windstorm. In the findings for the state's carbon monoxide alarm law, the legislature noted that more than a thousand people in Washington were seen at emergency rooms with CO poisoning symptoms after those storms. You can read the Washington carbon monoxide alarm law (RCW 19.27.530) yourself. Most of those cases were not dryers, but the lesson carries over: in a closed-up Seattle house in winter, combustion exhaust has to get outside.

Warning Signs Your Gas Dryer Vent Is Blocked or Leaking
None of these signs proves you have a CO problem. All of them mean the exhaust is not leaving the house the way it should, and that's worth fixing before the heavy-laundry months.
Loads take two or three cycles to dry. This is the most common sign of a restricted vent in any dryer.
The laundry room feels hot, damp, or stuffy when the dryer runs, or you see condensation on the window or walls nearby.
The outside of the dryer or the clothes are unusually hot to the touch.
The exterior hood flap barely opens, or you feel weak airflow outside while the dryer is running.
Lint around the dryer door, behind the machine, or on the floor near the duct connection.
A crushed, kinked, or sagging duct behind the dryer or in the crawlspace.
Foil or white vinyl flex duct anywhere on the run. Those soft ducts tear and crush easily. Our foil vs vinyl vs rigid metal dryer duct guide covers what to replace them with.
Your CO alarm chirps or sounds while the dryer is running. Treat that as an emergency, not a nuisance.
If you're seeing two or more of these, read our full list of signs your Seattle dryer vent is clogged and get the vent looked at.
What To Do If Your CO Alarm Goes Off While the Dryer Is Running
Don't troubleshoot first. Get safe first.
Get everyone, including pets, outside into fresh air.
Call 911 from outside. If you smell gas, also call your gas utility from outside. Puget Sound Energy serves natural gas customers across most of the Seattle area.
Do not go back in until the fire department or utility says it is safe.
The U.S. Consumer Product Safety Commission lists the common symptoms of CO poisoning as headache, dizziness, weakness, nausea, vomiting, sleepiness, and confusion, and says to get to fresh air and call 911 if you suspect it. Their carbon monoxide safety guidance is worth a five-minute read.
Once the house is cleared, don't run the gas dryer again until the venting has been inspected.
A Five-Minute Gas Dryer Vent Check for November
You can do this without tools. Do it with the dryer off and cool.
Look behind the dryer. The duct should be firmly attached to the dryer outlet and the wall. It should not be crushed flat against the wall or kinked into a tight U.
Check the material. Smooth rigid or semi-rigid metal is what you want. Foil accordion or plastic duct should come out.
Go outside and find the vent. Make sure the hood isn't packed with lint, blocked by plants or stored items, or covered by a screen. Screens trap lint fast; see why in the case against dryer vent screens.
Run the dryer and feel the airflow at the outside hood. You should feel a strong, warm push of air and see the flap open fully.
Test your CO alarm. The CPSC recommends CO alarms on every level of the home and outside sleeping areas. If your laundry room is near the bedrooms or the furnace, make sure an alarm is close by.
Never vent a gas dryer indoors. Indoor lint-catcher kits are sold for electric dryers, not gas units, and gas dryer manufacturers require exhaust to go outside.
What a Professional Gas Dryer Vent Cleaning Covers
A homeowner can clean the lint screen and the first few feet of duct. The rest of the run, through walls, floors, crawlspaces, and up to the roof, is where lint really builds up and where joints come apart without anyone seeing them.
When we service a gas dryer vent in Seattle, we:
Clean the full length of the vent from the dryer to the termination, including roof caps when the run goes up.
Check that the duct is connected at every joint we can reach, not just behind the dryer.
Look for crushed, sagging, or wrong-material duct, and tell you plainly what needs replacing.
Clear and check the exterior hood or roof cap so the flapper opens and closes freely.
Check airflow when we're done, so you know the exhaust is actually leaving the house.
We don't work on gas lines or burners. If we see something on the gas side that worries us, we'll tell you to call a licensed gas appliance technician or your utility.
You can see what's included for homes on our residential dryer vent cleaning page. For condos, apartments, and HOAs with shared shafts, see our commercial and HOA dryer vent service and our post on Seattle condo dryer vents and HOAs.
How Often Should a Gas Dryer Vent Be Cleaned in Seattle?
Most Seattle homes should have the dryer vent cleaned at least once a year, and more often for big households, pets, long runs, or rooftop terminations. A gas dryer doesn't make more lint than an electric one, but a blocked gas dryer vent has more ways to cause trouble. If it has been more than a year, or you don't know when it was last cleaned, get it done before the holidays and the wet months. Our guide on how often to clean a dryer vent in Seattle walks through the timing.
FAQ
Can a clogged dryer vent cause carbon monoxide?
A clogged vent on a gas dryer can. The burner makes carbon monoxide as part of its exhaust, and if the vent is blocked or disconnected, that exhaust can spill into the house instead of going outside. Electric dryers don't burn fuel, so they don't make CO, but a clogged electric dryer vent is still a fire risk.
Do I need a carbon monoxide alarm if I have a gas dryer?
Yes. Any home with a gas appliance should have working CO alarms. Washington's building code requires CO alarms in most residential buildings, and homes sold since 2009 must have them before the buyer moves in. The CPSC recommends one on every level and outside sleeping areas.
Can I use an indoor dryer vent kit on a gas dryer?
No. Gas dryer exhaust must go outdoors. Indoor vent kits are meant for electric dryers only.
How do I know if my gas dryer vent is disconnected?
You often can't tell from the laundry room. Weak airflow at the outside hood, a hot or damp laundry room, and long dry times are the usual clues. A professional inspection of the whole run is the reliable way to find a hidden disconnect.
Get Your Gas Dryer Vent Checked Before the Wet Months
If you run a gas dryer in Seattle and can't remember the last time the vent was cleaned, don't wait for a long dry time or an alarm to tell you. Book a dryer vent cleaning online, call us at 206-289-0344, or email info@SeattleDryerVentCleaning.com. We'll clean the full run, check the connections, and make sure the exhaust is going where it belongs: outside.


Comments